Filter

Support
Luxor ZD/ZDC

Luxor - Backing up Controller Program

Tabs

Read Article

The programming in the Luxor Power Controller can be backed up onto an SD card.

IMPORTANT: The SD card must be a SD or SD-HC. SD-XC should NOT be used. SD-XC cards do not work with the Luxor.

  • FAQ, Installation

Step 1

Start by pulling on the right sidetab and removing the facepack. Insert the SD card as shown. SD card will click into place. To remove SD card, press gently on card to eject.

Step 2

From the Luxor Home Screen, turn the navigation dial to Setup, press the dial once.

Step 3

Turn the navigation dial to Backup, press the dial once.

Step 4

To name the backup file press the navigation dial, turn the dial to select first character and press the dial to set. Turn the dial to next character and repeat procedure to complete backup file name. Once file is named turn the dial to Backup and press the dial to save file. Screen will dispaly Backup successful.

To restore the backup file, insert the SD Card into facepack. Turn the dial to Setup, then Backup, then select Restore. Backup file name from SD card should display, press the navigation dial to restore file.

Rate this Article: 
4.333335
Average: 4.3 (3 votes)

Was this article helpful? Yes | No