Luxor ZD/ZDC

Luxor - Fuse Replacement


Read Article

If the unit is powering on but the fixtures attached are not receiving power, the fuse may need to be replaced. To replace, follow the directions below:

  1. Unplug the Luxor ZD from power.
  2. Remove all wires from common and 14V terminals on the chassis.
  3. Remove four screws from the Fuse Cover.
  4. Remove and replace the fuse with the following specifications:
    • 5 X 20 mm
    • 250V
    • 10 Amp
    • UL Rated
  5. Replace the cover and 4 screws, reattach fixture wires and restore power to the unit.
Rate this Article: 
No votes yet

Was this article helpful? Yes | No