Filter

Support
Luxor ZD/ZDC

Luxor - Mounting Transformer

Tabs

Read Article
  • Installation
Wall Mount

By code, all transformers must be installed a minimum of 12” above finish grade as measured from finish grade to the bottom of the transformer.

  1. Drill ⅛" pilot holes into the mounting surface, insert anchors, and install screws into the anchors, leaving approximately ⅛" of thread exposed. Mount the transformer.
  2. Mark locations for bottom anchors with a permanent marker.
  3. Remove the transformer from the wall. Drill bottom anchor holes and install anchors.
  4. Place the transformer back on top of anchors and install screw(s) into anchors at bottom of the transformer to secure it to the wall.

A - Side View
B - Front View

  1. 1½" conduit
  2. 120 volt receptacle with weatherproof cover
  3. Power cord
  4. 12" minimum
  5. Mounting brackets
Post Mount

Install pressure treated 4” x 4” x 36” (min) post in concrete footing. Install single anchor screw 11⁄2”–2” below the top of post. Place transformer on screw. Once level, secure transformer to post by installing 1 or 2 screws on the bottom-mounting bracket.

A - Side View
B - Front View

  1. 1½" conduit
  2. 4 x 4 post
  3. Concrete footing
  4. 12" minimum
  5. Mounting brackets
Rate this Article: 
5
Average: 5 (1 vote)

Was this article helpful? Yes | No