Filter

Support
Luxor

Luxor - Fuse Replacement

Tabs

Read Article

If the Luxor Facepack is powering on, but the fixtures attached are not receiving power, the fuse may need to be replaced. To replace, follow the directions below:

Replacing the Fuse
  1. Unplug the Luxor controller from power.
  2. Remove all wires from common and 15V terminals on the chassis.
  3. Remove the four screws from the fuse cover.
  4. Remove and replace the fuse with the following specifications: 5 mm x 20 mm, 25-volt, 10-amp, UL rated
  5. Replace the cover and four screws, reattach the fixture wires, and restore power to the unit.
Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No