Filter

Support
Wall Lights

VK - LED Board Replacement

Tabs

Read Article

Tools Required:

  • #2 Philips screwdriver
  • 2 mm Allen key
  • Soft-edged pry device (e.g., small flathead screwdriver)
  • FAQ, Installation, Programming

Step 1

Turn OFF power to the fixture completely before disassembling. 

Step 2

Remove the TWO SCREWS from the faceplate with a 2 mm Allen key. The faceplate and housing can now be removed for LED board access. 

Step 3

Unfasten the SCREWS holding the LED board in place.

Step 4

Remove the LED BOARD by using a small, soft-edged pry device to gently lift one side of the board. Ensure the metal surface where the LED was removed is clear of debris or residual thermal pad material.

Step 5

Once the LED board is successfully removed, perform this procedure in reverse to reinstall the replacement LED board. Not all boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Also, remove any residue left on the fixture from the old LED board prior to installation of the new one. A pink-colored thermal pad is attached to the bottom of all FX Luminaire LED boards and should be left in place. Compatible LED boards for this fixture include ZDCKITM (COLOR), KITZD1LEDRDW-KITZD3LEDRDW (ZD), and KIT1LEDRDW-KIT3LEDRDW (zoning)

 

If using a Luxor® Controller with group numbers currently assigned, the new LED board will have to be assigned a group number. There are two options:
1. If you have a Wi-Fi module installed and the Light Assignment Module (LAM) accessory, the LED board can easily be assigned a group number with the fixture installed. Learn more
2. If you do not have a LAM, you can bring the fixture back to the controller to program the group number. Learn more

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No