Filter

Support
Wall Lights

HS - Install Notes

Tabs

Read Article

Step 1

Install SLEEVE into the wall during construction. Place bracket in a horizontal or vertical position as needed.

Step 2

Run the wiring through the SLEEVE and secure with strain relief connector.

Step 3

Use a VOLTMETER to ensure 11 to 15 V at the fixture and apply installation cover.

Step 4

Post-construction, remove installation cover.

Step 5

Connect wiring with a WATERPROOF CONNECTORLearn more

Step 6

Slide fixture into the SLEEVE and fasten SCREWS with 7/64" Allen key.

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No