SF - LED Board Replacement

Tabs

Read Article

The LED board is a replaceable part that can be changed with a few simple steps. To purchase the LED Board Replacement Kit for the SF Surface-Mounted Wall Light, find an authorized FX Luminaire distributor near you using our interactive Distributor Lookup.

Tools Required:

2 mm Allen key
2.5 mm Allen key
Soft-edged pry device (e.g., small flathead screwdriver)

FAQ, Installation, Programming

Step 1

Turn OFF power to the fixture completely before disassembling.

Step 2

Loosen the SCREW from the faceplate assembly with a 2 mm Allen key.

Step 3

Using an 2.5 mm Allen key, unfasten the SCREWS holding the reflector and LED board in place.

Step 4

Remove the LED BOARD by using a small, soft-edged pry device to gently lift one side of the board. Ensure the metal surface where the LED was removed is clear of debris or residual thermal pad material.

Step 5

Once the LED board is successfully removed, perform this procedure in reverse to reinstall the replacement LED board. Not all boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Also, remove any residue left on the fixture from the old LED board prior to installation of the new one. A pink-colored thermal pad is attached to the bottom of all FX Luminaire LED boards and should be left in place. Compatible LED boards for this fixture include the ZDCKITR (COLOR), 755905 (ZD1LED Warm 2,700K), and 755906 (ZD1LED Cool 3,000K).

When using a Luxor® Controller with assigned group numbers, you'll need to assign a group number to the new LED board. You can do this in two ways:

If a Wi-Fi Module and Light Assignment Module (LAM) are installed, you can easily assign a group number with the fixture installed. Learn more
If a LAM is not installed, bring the fixture back to the Luxor Controller to program the group number. Learn More

Rate this Article:

No votes yet

SupportWall Lights