Filter

Support
Up Lights

XA/XW - Install Guide

Tabs

Read Article

The Luxor® controller automatically displays the lighting assignment screen when an FX Luminaire LED fixture or device containing FX Luminaire ZD Technology® or ZDC Technology® is connected to the assignment ports on the controller facepack.To enter this mode, navigate to Setup and select Assign. Learn More

NOTE: The Exa Collection of fixtures requires the firmware v0.11 or higher to be compatible with the LAM (Light Assignment Module). Learn More

Step 1

Pound stake into ground.

Step 2

Thread fixture into the stake. Coil extra wire for future servicing.

Step 3

Use voltmeter to ensure 11 to 15 V at fixture.

Step 4

Connect wiring with waterproof connector.

Step 5

Aim fixture as desired.

Step 6

Rotate fixture for glare control. Loosen set screw and adjust fixture, then retighten set screw.

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No