Filter

Support
Up Lights

Designer Uplights - Installation

Tabs

Read Article

For predictable, high-performance lamp life, supply the fixture per the lamp manufacturer's requirements. For halogen lamps, supply 10.5 to 11.5 VAC. For LED lamps supply 11-15 VAC.

NOTE: Uplight fixtures are not designed to be installed as downlights. Reference our downlights product page for options. Learn More

Step 1

Pound STAKE into the ground and level.

Step 2

Thread on the LOCK RING. Do not tighten.

Step 3

Thread fixture into the stake by turning clockwise. Tighten down included LOCK RING to position the aim of the fixture. Coil extra wire for future servicing. 

Step 4

Loosens SCREW on the side of fixture (depending on the fixture, this could be a flathead or Phillips screw). Adjust the fixture direction and tighten the screw.

Step 5

Use a VOLTMETER to ensure proper AC voltage at the fixture. For halogen lamps, supply 10.5 to 11.5 VAC. For LED lamps supply 11-15 VAC.

Step 6

Connect wiring with a WATERPROOF CONNECTORLearn more

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No