Filter

Support
Up Lights

WS - Lamp Replacement

Tabs

Read Article
WS
  • FAQ, Installation, Programming

Step 1

Turn off power to the fixture completely before disassembling.

Step 2

To remove the outer shroud, use a 9/64" hex key to loosen the setscrews on each side. Then, pull off the lens assembly.

Step 3

Remove the lamp by carefully pulling upward until the two pins are free from the socket.

Step 4

Once the G4 LED lamp (p/n G4LED35W) is successfully removed, perform this procedure in reverse order to reinstall the replacement lamp. Ensure the seal is properly seated prior to securing the faceplate. Not all lamps will fit in every fixture, so ensure the fixture can accommodate the selected lamp prior to maintenance. Compatible lamps for this fixture include: G4LED10W, G4LED20W, G4LED35W, 250010260001 (Xenon 10W), and 250010260003 (Xenon 20W).

Use our interactive Distributor Lookup to find an authorized FX Luminaire distributor near you.

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No