Filter

Support
In-Grade Lights

XN - LED Board Replacement

Tabs

Read Article

Tools Required:

  • #2 Phillips screwdriver
  • Soft-edged pry device (e.g., small flathead screwdriver)

XN - LED Board Replacement:

Description Catalog #
LED Board, H1, Warm 2,700K KITH1W
LED Board, H1, Soft 3,000K KITH1S
LED Board, Zone/Dim, H1, Warm 2,700K KITZDH1W
LED Board, Zone/Dim, H1, Soft 3,000K KITZDH1S
LED Board, ZDC, 6 LED KITZDC6
Assembly, Optics, H1, Beam Angle KITOPXA70H1YY
Assembly, Optics, ZDC KITOPXA70ZDC

Zone, Zone/Dim, and ZDC boards are not interchangeable on the same fixture.

Find a Distributor

Step 1

Turn Off power to the fixture completely before disassembling.

Step 2

Remove the four screws to access the internal components. Remove Faceplate and Lens assembly.

 

Step 3

Remove the Cap by pulling it upward.

Step 4

Remove the Filter by lifting the reflector upward.

Step 5

Remove the three Screws holding the reflector and LED board in place. Remove the reflector.

Step 6

The LED board can now be removed. Using a small, soft-edged pry device, gently pry up on one side of the board. Ensure the base of the reflector where the LED was removed is clear of debris or residual thermal pad material.

Step 7

Once the LED board is successfully removed, perform this procedure in reverse to install the replacement board. Not all the boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Also remove any residue left on the fixture from old LED board prior to installation of the new one. All the FX Luminaire LED boards come with a pink thermal pad attached to the bottom that should be left in place.

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No