Filter

Support
In-Grade Lights

Changing the LED Board on the BQ Light

Tabs

Read Article
BQ

Tools Required:

  • #2 Philips screwdriver
  • Soft-edged pry device (e.g., small flathead screwdriver)
  • FAQ, Installation

Step 1

Turn off power to the fixture completely before changing the LED board in any fixture.

Step 2

Remove lens assembly from the BQ fixture by pulling it off of the fixture.

Step 3

Remove the filter from the fixture by twisting it counter-clockwise and lifting it off

Step 4

Remove the two screws holding the reflector and the LED board to the fixture using a small Phillips screwdriver.

Step 5

The LED board can now be removed. Using a small soft edged pry device gently pry up on one side of the board. Make sure the base where the LED was removed is clear of debris or residual thermal pad material.

Step 6

Once the LED board is successfully removed, perform this procedure backwards to install the replacement board. Not all boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Also remove any residue left on the fixture from old LED board prior to installation of new one. All FX LED boards come with a pink colored thermal pad attached to the bottom that should be left in place.

Find an authorized FX Luminaire distributor near you using our interactive Distributor Lookup.

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No