Filter

Support
In-Grade Lights

HP48 - Install Guide

Tabs

Read Article

The drive-over-rated HP-48 seamlessly integrates with standard (4" x 8") paver systems. 

The rating can be referenced in the chart below.

FIxture Drive-Over Rating
HP-48 4,496 lbs

INSTALLATION STEPS

 

Step 1

Install conduit, construction housing, and cover into the ground during construction. Run wiring into construction housing.

Step 2

Use a VOLTMETER to ensure 11-15 VAC at the fixture.

Step 3

Connect wiring with a WATERPROOF CONNECTORLearn more

Step 4

Press FIXTURE into housing.

Step 5

For servicing, use two flathead screwdrivers to remove fixture from housing.

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No