Filter

Support
Path Lights

PP-36 - LED Board Replacement

Tabs

Read Article

An LED might need to be replaced for a couple of reasons, including:

  • Burnout or failure: Although LEDs have a long lifespan, they can still fail due to overheating from an electrical surge or water intrusion.
  • Flickering: If an LED light starts to flicker, it may not indicate a bad LED board, so we advise proper testing before replacement. Learn More

When using the Luxor® Controller and you currently have group numbers assigned, the new LED board will have to be assigned a group number. There are two options:
1. If you have a Wi-Fi module installed and the Light Assignment Module (LAM), the LED board can easily be assigned a group number with the fixture installed. Learn more
2. If you do not have a LAM, you can bring the fixture back to the Luxor to program the group number. Learn More

Tools Required:

  • Soft-edged pry device (e.g., small flathead screwdriver)
  • Small Phillips screwdriver

Step 1

Turn off the power on the lighting transformer completely before disassembling the fixture.

Step 2

Remove the shroud by twisting it to the left, then pulling it outward.

Step 3

Gently remove the beam angle lens and hex baffle.

Step 4

Remove the reflector by twisting it counterclockwise and pull outward.

Step 5

Remove the two Phllips screws holding the reflector and LED board in place. 

Step 6

Remove the LED board by prying up one side with a flat edge device, then pull outward.

Step 7

Once the LED board is successfully removed, you can perform this procedure backward to reinstall the replacement LED board. Not all boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Compatible LED boards for this fixture include: 

Description Part #
1 LED Up Light Kit (2700K) DKIT-1LED-W-RD-OP
1 LED Up Light Kit (3000K) DKIT-1LED-S-RD-OP
3 LED Up Light Kit (2700K) DKIT-3LED-W-RD-OP
3 LED Up Light Kit (3000K) DKIT-3LED-S-RD-OP
ZD 1 LED Up Light Kit (2700K) DKIT-ZD-1LED-W-RD-OP
ZD 1 LED Up Light Kit (3000K) DKIT-ZD-1LED-S-RD-OP
ZD 3 LED Up Light Kit (2700K) DKIT-ZD-3LED-W-RD-OP
ZD 3 LED Up Light Kit (3000K) DKIT-ZD-3LED-S-RD-OP
ZD 3 LED T Up Light Kit (TURTLE) DKIT-ZD-3LED-T-RD-OP
ZDC 3 LED Kit, Medium DKIT-ZDC-3LED-RGBW-MD-OP
Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No