Filter

Support
Path Lights

Changing the LED Board on the PM Path Light

Tabs

Read Article
PM
  • FAQ, Installation

Step 1

Its always a good idea to change the LED boards with power to the transformer turned off completely. To remove the PM cap and lens, carefully loosen the Allen screw (1/16) at the top of the fixture. 

Step 2

Remove the cap and lens by pulling upward to access the LED board and filters. 

Step 3

The filter can be removed easily by turning counter clockwise.

Step 4

Depending on the size of the LED board, you will have two to three Phillips head screws that need to be removed to access the LED board below the reflector. Carefully remove these screws by turning each counter clockwise.

Step 5

The LED board can now be removed.  Using a small flat bladed screwdriver to pry up gently on one side of the board taking into account the two pins on the bottom. Make sure the base of the fixture where the LED was removed from is clear of debris or residual thermal pad material.

Step 6

Once the LED is successfully removed this procedure can be performed backwards to install the replacement board.  Replacement boards will have to be the same size LED to fit properly.  All new FX LED boards come with a clear plastic coating on the back of the thermal pad, this must be removed prior to install. Replace the board being very careful the pins are lined up appropriately.

Find an authorized FX distributor near you using out interactive Distributor Lookup.

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No