Filter

Support
Specialty Lights

LL - LED Board Replacement (New Style)

Tabs

Read Article

Tools Required:

  • #2 Philips screwdriver
  • 7/64” Allen Key
  • Soft-edged pry device (e.g., small flathead screwdriver)

Step 1

Turn off power to the fixture completely before disassembling. 

Step 2

Remove the screw from the bottom of the back cap using a 7/64" Allen key. 

Step 3

Remove the six screws from the bottom of the internal body using a 7/64" Allen key. Remove the shroud. 

Step 4

Remove any filters from the reflector by turning them counterclockwise and lifting off the reflector. 

Step 5

Unfasten the screws holding the reflector and LED board in place. Remove the reflector

Step 6

Remove the LED board by using a small, soft-edged pry device to gently lift one side of the board. Ensure the metal surface where the LED was removed is clear of debris or residual thermal pad material.

Step 7

Once the LED board is successfully removed, perform this procedure in reverse to reinstall the replacement LED board. Not all boards will fit in every fixture, so ensure the fixture can accommodate the selected board prior to maintenance. Also, remove any residue left on the fixture from the old LED board prior to installation of the new one. A pink-colored thermal pad is attached to the bottom of all FX Luminaire LED boards and should be left in place. Compatible LED boards for this fixture include: ZDCKITL (COLOR), ZD1LEDULKIT-ZD3LEDULKIT-ZD6LEDULKIT-ZD9LEDULKIT (ZD), and 1LEDULKIT-3LEDULKIT-6LEDULKIT-9LEDULKIT (standard).

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No