Filter

Support
Line-Voltage Lights

A-ST5 - Installation Notes

Tabs

Read Article

Caution and Safety Instructions

  • Qualified personnel must install and/or service product in a manner consistent with its intended use and in compliance with the National Electrical Code, Canadian Electrical Code, and/or all local and provincial codes.
  • Follow all product label information and installation instructions.
  • Turn off power at fuse or circuit breaker before installation or servicing.
  • The use of damaged components may cause an unsafe condition and void product warranty.
  • Do not block light emanating from product in whole or part.
  • Never operate the luminaire with missing or damaged lens. Clean lens on a regular basis.
  • Entire luminaire may become extremely hot. Do not touch hot lens or luminaire body. Do not touch the light source at any time.
  • Keep all O-rings and sealing surfaces clean during installation and servicing; failure to do this may lead to premature failure of the product.
  • FAQ, Installation, Programming
Step 1

Secure the mounting bracket to the installed junction box (provided by others). Ensure the mounting bracket holes and tabs are at the top and bottom.

Step 2

Connect the fixture wiring using the wiring diagram and approved wire connectors.

Step 3

Attach the base of the fixture to the top of the mounting bracket.

Step 4

Tighten the setscrew with a 5/64″ Allen key to lock the base of the fixture to the mounting bracket.

Wiring Chart

Rate this Article: 
0
No votes yet

Was this article helpful? Yes | No