Wall Lights - PO, VO, MO, CN-51, & CG-51

Tabs

Read Article

Each fixture is designed for use with Schedule 40 conduit, which can be cut to the required length. The conduit must fully enclose the fixture base and must be at least 7½ inches long.

Model	SCH 40 Size (Outside Diameter)	Core Drill Size (With Conduit Sleeve)	Core Drill Size (Without Conduit Sleeve)
PO	1 ½" (1.9")	2"	1 ½''
VO (with included orange o-ring)	1 ½" (1.9")	2"	1 ½''
MO	2" (2.375")	2 ½"	2''
CN-51	2 ½" (2.875")	3"	2 ½''
CG-51	2 ½" (2.875")	3"	2 ½''

Step 1

Use the provided conduit and trim length if necessary.

Step 2

Install conduit sleeve into the wall during construction. Run fixture wiring through sleeve. *Coupling for VO fixture only.

Step 3

Press the faceplate into the sleeve. Level and orient fixture as desired.

Step 4

For the concrete ground-mount option, use construction housing. The VO-ST is rated for a load of 992 lbs. Applies to the VO fixture only.

Step 5

Use a voltmeter to verify 11-15 V at the fixture.

Step 6

Connect the wiring with a waterproof connector.

Rate this Article:

No votes yet

SupportWall Lights