FXL Technical Support Document
Assigning a Fixture to an FX Luxor Transformer
The lighting assignment screen is an automatically displayed screen when an FX ZD fixture or board is connected into the Programming Ports of the facepack. This mode can also be forced by navigating to SETUP and selecting ASSIGNMENT MODE.
| STEP ONE | STEP TWO |
|---|---|
|
Enter this mode by placing two separate wires from a single Luxor ZD fixture or board into each of the PROGRAMMING PORTS on the front of the facepack. The fixture must remain connected to the facepack during the entire process. FX LED boards can also be attached to a socket and programmed through the Fixture Programming Ports. |
Once connected and at the Assignment Screen, select the group that you would like the fixture to be a part of. |
| STEP THREE | STEP FOUR |
|
Using the scroll wheel, navigate to PROGRAM and press the scroll wheel to initiate assignment. |
When complete the screen will show "Assignment Succeeded" or "Assignment Failed". If failed, return to Step One. If the problem persists the board may be defective or not a ZD board. |
Still not finding the answers?
Hunter Technical Support experts are available to answer your question(s) about Hunter products and their usage, simply click on the contact button below to submit an email request.
